CHEVROLET LATE MODEL HEI MARINE DISTRIBUTOR

Source: go.mrgasket.com
Topic: Chevrolet

Short Desciption:
CHEVROLET LATE MODEL HEI MARINE DISTRIBUTOR (External Coil) PART NO. 9-26700 (YLE624AV) PART NO. 9 ... See service manual for this location. Mark the distributor cap and distributor housing at this spark ...

 

Content Inside:
CHEVROLET LATE MODEL HEI MARINE DISTRIBUTOR (External Coil) PART NO. 9-26700 (YLE624AV) PART NO. 9-26701 (YLE624BV) OLD DISTRIBUTOR REMOVAL STEP 1 Disconnect both wire connections at the ignition module (make note of the position of the module). Locate the spark plug wire on the original distributor cap that is used to set engine timing. See service manual for this location.  Mark the distributor cap and distributor housing at this spark plug wire position. STEP 2 Turn the engine crankshaft in the direction of rotation until the timing mark lines up with the top dead center (TDC) mark on the timing tab. See service manual for these locations. STEP 3 Remove the distributor cap from the distributor. Do not remove spark plug wires or coil wire at this time. Make sure the rotor blade points to the mark on the distributor housing (from Step 2). If it does not, repeat step 2 until the timing mark lines up (again) with the TDC mark on the timing tab. NOTE: Once you are finished with Step 3, DO NOT turn the crankshaft until the new distributor is installed. STEP 4 Note the direction the rotor is pointing. Remove the distributor hold-down clamp and remove the distributor from the engine. NEW DISTRIBUTOR INSTALLATION STEP 1 Remove the cap from the new Mallory distributor. STEP 2 Place the Mallory Distributor in the engine, making sure that both the rotor and module are in the same position as the old distributor. This will generally set timing close enough for starting purposes. Put the distributor hold down clamp in place and tighten slightly, leaving it loose enough to turn the Mallory distributor. STEP 3 Install the new cap. Remove the spark plug wires from the original cap and install them onto the new Mallory cap. Do this one at a time, making sure they are in the same location from the original cap to the new cap. STARTING THE ENGINE CAUTION: Be sure all tools, wires and miscellaneous ...

 

 

hei distributor install for marine, wiring diagram for gm hei distrubutor, late model telecharger, will chevy hei work on a boat, 350 chevy timing mark picture, chevy 350 boat distributor, chevy 350 marine diagram, marine chevy 350 timing setting with electronic distributor, marine 350 head diagram, marine distributor for chevy 350, gm external coil hei wiring diagram, ignition wiring harness for chevy hei, how install hei marine distributor, gm hei distributor scanner hookup, base timing for chevy 350 hei, base timing for chevy 350 hei, 350 chevy distributor installation, remove distributor pdf, remove distributor pdf, chevy 350 hei ignition wiring diagram